Until now, the most common tool for drawing hand-sewn lines has been a steel divider (compass).
However, because they are not designed for leather crafts but for steel, they have three disadvantages.

1. When drawing a line, it comes off the edge of the leather and damages the leather.
2. The sharp tip cuts the leather when drawing a line.
3. The tip is unstable due to its structure (spring structure) that does not allow the width to be fixed. Also, the width will be different each time it is used.
・
This product was developed as a Divider exclusively for leather craft.
In developing this product, the following points were taken into consideration.

1. When drawing a line, make sure it does not shift from the Leather.
We changed the height of the Width Determination Guide and Divider to accommodate this.

2. The construction should be such that the leather does not break when the line is drawn.
Therefore, we responded by making the tip of the divider tapered and angled so that the leather would not break.

3. Fix the width of the shaft part by making it a screw structure.
Changed from a spring structure [conventional product] to a screw structure.
This was done by eliminating the movement of the shaft and the width-fixing guide.

4. Make it usable for Pro Stitching Groover.
・
The following are features
(1) About Divider Replacement Blades
The divider blade is made of tool steel.
The entire blade is hardened.
The hardening process increases the hardness of the metal, so the tip is rounded and the line is not thickened.
The entire piece is finished with [24k gold plating].

(2) About the tip of the divider
The tip is tapered to an angle that does not cut the leather when a line is drawn.
Since it is made exclusively for leather craft, it is possible to draw an ultra-fine line.
The extra-fine line prevents the tip of the diamond hole punches from being misaligned.
The blade is protected by a tube before shipping.

(3) About the width of the line
Lines can be drawn from approximately 1mm to 12mm from the edge of the leather.

(4) About the width guide
By changing the direction of the width guide, it can be used for both left-handed and right-handed use.
The guide can be fixed so that line drawing is stable.
The width does not change every time it is used.

(5) Use as ballpoint styles
Remove the width guide and use as ballpoint styles.

(6) About Body
The spring structure (conventional product) has been changed to a screw structure.
The check eyes on the body are non-slip for fixing the guide.
The entire body is plated to prevent rust.

(7) About the imprint
The product is imprinted with JAPAN (OKA Factory's manufacturing mark).

Even if you are already using Pro stitching groover, you can use it by purchasing only Divider Blade.