-About other companies' products-
There were some bad parts in our company's opinion.
(1) The part where the metal fittings contact the product has cutting scratches from the machining process.
(2) The shape is not the same as that of the metal fittings.
(3) The part where the metal fittings hit should be deep.
This caused scratches to appear on the metal fittings, deformed the shape, and left batter marks on the leather.

-OKA Factory's commitment-
This product was developed to prevent scratches on the metal fittings, deformation of the shape, and marks on the leather.
(1) As a measure to prevent scratches, we focused on the mirror finish of the Rivet setter.
(2)As a measure to prevent deformation, Rivet setters are made with the same shape of metal fittings.
Since the impact of a blow is applied to the entire shape of the fitting, the fitting is not deformed.
(3)The depth at which the metal fittings hit the leather has been made "a little shallower" as a measure to prevent the Rivet setter from leaving marks on the leather.
Therefore, there are no Rivet setter marks on the leather.

-About the handle-
The handle is coated with a non-slip protection.
Fingers do not slip and work can be performed securely.

-About Plating-
The entire Rivet setter is plated to prevent rusting.

-About the imprint-
Size and MADE IN JAPAN are imprinted.

-Precautions for use-
Do not use a hammer when striking.
It may cause deformation of the Rivet setter and rusting due to peeling of the plating.
Wood hammer maul, round maul, and mallet are recommended.